#9122
V8 Staff
Keymaster

Here’s the first jig we built:

4X4″ box iron

Legs bolt in, end up being flush to top surface

After paint and measuring center. Lower pieces allow for installation of a cross bar to move it with a jack.

Frame stand leg, this one made for a 1st gen Camaro.

Everything checked and squared with a laser guide.

Tram gauge used to center holes for body mounts

Camaro rails and floor attached. We used the GM crash data sheets to determine the length of the frame stand legs.

Check out:
V8 Radio Podcast: https://www.v8radio.com
V8TV YouTube Channel: https://www.youtube.com/user/V8TV