V8 Speed and Resto Shop – We Build And Restore Custom Hot Rods and Muscle Cars for Enthusiasts All Over The World! › Forums › V8 Speed and Resto Shop Forum › Your Project Car – Member Rides & Build Threads › 1964 Chevy Nova 400 2 door sedan › Re:1964 Chevy Nova 400 2 door sedan
My first 3D printed part from the new 3D printer. It is printed in ABS plastic and contains one magnet and one dummy washer to give one pulse per rev of the driveshaft.
Since the trans is converted to drive a mechanical speedo, a speed signal for the ECU
was needed. The stock VSS sent a signal to the Astro gaugecluster where it was converted in to 2000 pulse per mile.This collar contains one magnet that gives the ECU approx 2700 ppm which is close enough to get the converter lockup to work ok, and to enable highway mode for the ECU.
/Goran
Nice job! Does the part work as designed? It’s cool to see a useful part made with the 3D printer to solve a problem. Thanks for the update!
Kevin Oeste